Lewmar will exhibit at METSTRADE 2026 with its docking and manoeuvring equipment. The show’s official profile confirms the company at stand 12.402, while Lewmar’s own product information describes proportional thrusters with variable thrust control and brushless motors for 24V installations.
This is not a promise that every existing yacht will gain more lateral force. The practical change is controllable thrust rather than simple on/off bursts. That may make close-quarters work easier in wind or a tight marina, but the result still depends on hull design, unit size, tunnel, batteries and control installation.
Start a retrofit with an audit
Lewmar says selected proportional solutions are suitable for retrofit. Before ordering, however, the owner’s team needs to verify the precise model, tunnel diameter, voltage, cabling, protection, controller space and load on the 24V system. Mechanical fit alone does not confirm electrical compatibility.
The duty cycle matters as well. Lewmar describes a brushless design and long running capability limited by battery capacity. That does not remove the need to calculate the energy balance, thermal demand and actual installation parameters with a competent installer.
An operational decision, not a brochure choice
Owners should weigh the upgrade cost against the real operational issue: difficult marina approaches, crew size, cruising pattern and the condition of the existing arrangement. Parts availability and service support in the intended operating area deserve the same attention.
METSTRADE runs from 17 to 19 November in Amsterdam. A stand visit can produce useful specification sheets, but it cannot replace a system design for a particular hull. Our yacht-refit economics guide adds broader context; W Yachts can help turn operational needs into a defined brief before quotes are requested.
Good commissioning should also include a handover check under load and a documented explanation of the controller modes for the regular skipper and crew.




