Blue-Airco is bringing two DC-powered air-conditioning developments to METSTRADE 2026: the SDC15V12E unit and a Multizone Control Kit. This is not a claim that every yacht can be upgraded in the same way. It is a useful prompt, however, to calculate cabin comfort alongside the battery bank, charging capacity and duct runs — rather than by catalogue cooling output alone.
What the manufacturer states
Blue-Airco says its SDC15V12E runs on 12V DC, delivers 15,100 BTU/h in tropical conditions and consumes 790W. In ECO mode, the company gives a lower operating point of 5,400 BTU/h at 170W. The unit uses R-454C, for which the company cites a GWP of 148. These are manufacturer specifications, not independent results from a particular yacht.
The second product is not another compressor. The Multizone Control Kit is intended to direct air from an existing A/C system to two independently controlled zones by means of a motorised shutter and BLDC fan. The METSTRADE listing gives the standard kit a 1.8kg weight, up to 200m³/h airflow and 22–24W consumption. It may reduce installation load, but it does not replace calculations for duct losses or confirmation that one unit can cover simultaneous heat gain in two cabins.
Questions before a refit
Before placing an order, an owner should request a calculation for the difficult case: generator-free time at berth, high seawater temperature and occupied cabins. The brief should also cover duct design, low-speed noise, condensate drainage and a service plan for the controller and fan. It should state the battery discharge window and charging source explicitly, rather than assuming a nominal 12V supply is continuously available.
On a smaller yacht especially, the benefit of zone control should be kept separate from a broad promise of “more comfort”. Two temperature settings are useful only if the crew can retain airflow, filtration and service access without dismantling joinery. As we noted in our guide to when a yacht refit makes sense, a low-cost upgrade can become expensive when its surrounding installation is ignored. A W Yachts client can use an independent checklist before specification, but the installer should confirm consumption and performance for the actual layout.




